Selector Shaft Seal, Replacing

Special tools and workshop equipment required 

• Seal Installer - Selector Shaft Oil Seal: T10174 

Perform the Following Procedure:

-- Remove the Multifunction Transmission Range Switch -F125-. Refer to MULTIFUNCTION TRANSMISSION RANGE SWITCH, REMOVING AND INSTALLING .

-- Carefully pry out the selector shaft seal with a screwdriver. Do not to damage the selector shaft when doing this.

-- Coat the outer edge of the oil seal and the sealing lips with ATF.

• Installed position: open side of the seal toward the transmission housing.

-- Install the new seal all the way using the Seal Installer - Selector Shaft Oil Seal: T10174  . Do not tilt the seal when installing it.

Fig 1: Identifying New Gasket Driven In Until Stop Using Thrust Piece T10174

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install and adjust the Multifunction Transmission Range Switch -F125-. Refer to MULTIFUNCTION TRANSMISSION RANGE SWITCH, ADJUSTING .