Overview - RHD, Abs Mark 70 (Abs/ASR)

WARNING: This page is about a different car, the 2018 Volkswagen Jetta, 2017 Volkswagen Jetta, 2016 Volkswagen Jetta, and 2015 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of RHD, ABS Mark 70 (ABS/ASR)

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Brake Line
- Brake master cylinder/secondary piston circuit to hydraulic unit
- Identification: tube fitting with threads M 12 x 1
- 14 Nm
Brake Line
- Brake master cylinder/primary piston circuit to hydraulic unit
- Identification: tube fitting with threads M 10 x 1
- 14 Nm
Brake Booster
- Overview. Refer to BRAKE BOOSTER/BRAKE MASTER CYLINDER .
Brake Line
- To the right front brake caliper
- Identification: tube fitting with threads M 10 x 1
- 14 Nm
Brake Line
- To the left front brake caliper
- Identification: tube fitting with threads M 12 x 1
- 14 Nm
ABS Control Module -J104-
- Removing and installing. Refer to ABS Control Module -J104- AND ABS Hydraulic Unit -N55-, REMOVING AND INSTALLING, RHD WITH ABS MARK 70 ABS/ASR .
- Disconnecting from the ABS Hydraulic Unit -N55-. Refer to ABS Control Module -J104-, SEPARATING FROM ABS Hydraulic Unit -N55- (MARK 70 ABS/ASR) .
Torx Socket Bolt
- Use new bolts.
- 5.5 Nm
ABS Hydraulic Unit -N55-
- Removing and installing. Refer to ABS Control Module -J104- AND ABS Hydraulic Unit -N55-, REMOVING AND INSTALLING, RHD WITH ABS MARK 70 ABS/ASR .
- Disconnecting the ABS Control Module -J104- from the ABS Hydraulic Unit -N55-. Refer to ABS Control Module -J104-, SEPARATING FROM ABS Hydraulic Unit -N55- (MARK 70 ABS/ASR) .
Bracket
Rubber Bushing
- When installing the bracket, make sure the rubber bushing does not push out of the bracket.
Bracket
- Before the assembly spray the rubber bushing -item ) OVERVIEW - RHD, ABS MARK 70 (ABS/ASR)- with Silicone Grease Spray
- after installing, make sure it fits properly
Hex Nut
- 20 Nm
Hex bolt
- 8 Nm
Brake Line
- To the left rear brake caliper
- Identification: tube fitting with threads M 12 x 1
- 14 Nm
Brake Line
- To the right rear brake caliper
- Identification: tube fitting with threads M 10 x 1
- 14 Nm