Overview - RHD, Abs Mark 60 EC (Abs/EDL/ASR/Esp)

WARNING: This page is about a different car, the 2018 Volkswagen Jetta, 2017 Volkswagen Jetta, 2016 Volkswagen Jetta, and 2015 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of RHD, ABS Mark 60 EC (ABS/EDL/ASR/ESP)

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Brake Line
- Brake master cylinder/secondary piston circuit to hydraulic unit
- Identification: 6.5 mm diameter and tube fitting with a M12 x 1 thread
- 14 Nm
Brake Line
- Brake master cylinder/primary piston circuit to hydraulic unit
- Identification: 6.5 mm diameter and tube fitting with a M12 x 1 thread
- 14 Nm
Brake Booster
- Overview. Refer to BRAKE BOOSTER/BRAKE MASTER CYLINDER .
Brake Line
- To the right front brake caliper
- Identification: 5.25 mm diameter and tube fitting with a M12 x 1 thread
- 14 Nm
Brake Line
- To the left front brake caliper
- Identification: 5.25 mm diameter and tube fitting with a M10 x 1 thread
- 14 Nm
ABS Control Module -J104-
- Removing and installing. Refer to ABS Control Module -J104- AND ABS Hydraulic Unit -N55-, REMOVING AND INSTALLING, RHD WITH ABS MARK 60 EC ABS/EDL/ASR/ESP .
- Disconnecting from the ABS Hydraulic Unit -N55-. Refer to ABS Control Module -J104-, SEPARATING FROM ABS Hydraulic Unit -N55- (ABS MARK 60 EC ABS/EDL/ASR/ESP) .
Torx Socket Bolt
- Use new bolts.
- 2 Nm + 0.8 Nm
Rubber Bushing
- When installing the bracket, make sure the rubber bushing does not push out of the bracket.
Bracket
Hex Nut
- 20 Nm
Torx Bolt
- 8 Nm
Bracket
- Before the assembly spray the rubber bushing -item ) OVERVIEW - RHD, ABS MARK 60 EC (ABS/EDL/ASR/ESP)- with Silicone Grease
- after installing, make sure it fits properly
Rubber Bushing
Hex Fitting Bolt
- 8 Nm
Brake Line
- To the left rear brake caliper
- Identification: 5.25 mm diameter and tube fitting with a M12 x 1 thread
- 14 Nm
Brake Line
- To the right rear brake caliper
- Identification: 5.25 mm diameter and tube fitting with a M10 x 1 thread
- 14 Nm
ABS Hydraulic Unit -N55-
- Removing and installing. Refer to ABS Control Module -J104- AND ABS Hydraulic Unit -N55-, REMOVING AND INSTALLING, RHD WITH ABS MARK 60 EC ABS/EDL/ASR/ESP .
- Disconnecting the ABS Control Module -J104- from the ABS Hydraulic Unit -N55-. Refer to ABS Control Module -J104-, SEPARATING FROM ABS Hydraulic Unit -N55- (ABS MARK 60 EC ABS/EDL/ASR/ESP) .