Overview - Abs Mark 60 EC (Abs/EDL/ASR/Esp)
WARNING: This page is about a different car, the 2018 Volkswagen Jetta, 2017 Volkswagen Jetta, 2016 Volkswagen Jetta, and 2015 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
- ABS Hydraulic Unit -N55-
- Removing and installing. Refer to ABS Control Module -J104- /ABS Hydraulic Unit -N55-, REMOVING AND INSTALLING .
- Disconnecting the ABS Control Module -J104- from the ABS Hydraulic Unit -N55-. Refer to ABS Control Module -J104-, SEPARATING FROM ABS Hydraulic Unit -N55- (ABS MARK 60 EC ABS/EDL/ASR/ESP) .
- ABS Control Module -J104-
- Removing and installing. Refer to ABS Control Module -J104- /ABS Hydraulic Unit -N55-, REMOVING AND INSTALLING .
- Disconnecting the ABS Control Module -J104- from the ABS Hydraulic Unit -N55-. Refer to ABS Control Module -J104-, SEPARATING FROM ABS Hydraulic Unit -N55- (ABS MARK 60 EC ABS/EDL/ASR/ESP) .
- Bolt
- 2 Nm ± 0.8 Nm
- Replace after removing.
- Quantity: 4
- Brake Line
- 14 Nm
- To the left front brake caliper
- Identification: 5.25 mm diameter and tube fitting with a M10 x 1 thread
- Brake Line
- 14 Nm
- ABS Hydraulic Unit -N55- for the brake master cylinder/primary piston circuit
- Identification: 6.5 mm diameter and tube fitting with a M12 x 1 thread
- Brake Line
- 14 Nm
- To the right front brake caliper
- Identification: 5.25 mm diameter and tube fitting with a M12 x 1 thread
- Brake Line
- 14 Nm
- ABS Hydraulic Unit -N55- to the brake master cylinder/secondary piston circuit.
- Identification: 6.5 mm diameter and tube fitting with a M12 x 1 thread
- Brake Line
- 14 Nm
- Brake master cylinder/primary piston circuit to the ABS Hydraulic Unit -N55-
- Identification: 6.5 mm diameter and tube fitting with a M12 x 1 thread
- Brake Line
- 14 Nm
- Brake master cylinder/secondary piston circuit to the ABS Hydraulic Unit -N55-
- Identification: 6.5 mm diameter and tube fitting with a M12 x 1 thread
- Brake Booster with Master Brake Cylinder
- Refer to BRAKE BOOSTER/BRAKE MASTER CYLINDER
- Brake booster, removing and installing. Refer to BRAKE BOOSTER, REMOVING AND INSTALLING .
- Brake master cylinder, removing and installing. Refer to BRAKE MASTER CYLINDER, REMOVING AND INSTALLING .
- Brake Line
- 14 Nm
- To left rear brake caliper/brake cylinder
- Identification: 5.25 mm diameter and tube fitting with a M12 x 1 thread
- Brake Line
- 14 Nm
- To the right rear brake caliper/brake cylinder
- Identification: 5.25 mm diameter and tube fitting with a M10 x 1 thread
- Hex Fitting Bolt
- 8 Nm
- Rubber Bushing
- Bracket
- After installing, make sure it fits properly
- Bolt
- 8 Nm
- Quantity: 3
- Nut
- 8 Nm
- Quantity: 2
- Bracket
- Rubber Bushing
- Do not press the rubber bushings out of the bracket when installing the bracket.