Peripheral Camera Control Module -J928-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2021 Volkswagen Tiguan, 2020 Volkswagen Tiguan, 2019 Volkswagen Tiguan, and 2018 Volkswagen Tiguan. However, it is still accessible from the selected car via links, so may be relevant.

-- Raise the front seat into its highest position and then move it all the way back.

-- Turn off the ignition and all electrical equipment.

-- Move the ignition key outside of the vehicle to prevent switching on the ignition unintentionally.

-- Remove the expanding rivets -arrows-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Push the cover -1- with the Peripheral Camera Control Module -J928-, straight in the direction of travel, while paying attention to the connected wires and turn.

-- Release and disconnect the connectors -3-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Release the catches on the cover -1- in the direction of the -arrow-.

-- At the same time remove the Peripheral Camera Control Module -J928- -2- from the cover -1-.