Passenger Occupant Detection System Control Module, Removing And Installing: Installing
Further installation is performed in reverse order of removal, while noting the following:
Pyrotechnical components can deploy unintentionally.
There is a risk of injury.
- Discharge static electricity by briefly touching the door striker.
Make sure the connectors are pushed in all the way and that they engage audibly.
If the Passenger Occupant Detection System Control Module -J706- was replaced, it is necessary to perform a basic setting/coding in Guided Fault Finding using the Vehicle Diagnostic Tester.
-- Connect the battery ground cable with the ignition switched on. Refer to BATTERY, DISCONNECTING AND CONNECTING .
Risk of airbag deployment.
There is a risk of injury.
- Switching on the ignition (key/button) after assembly may only be done when the driver seat is positioned all the way back.
If the Airbag Indicator Lamp -K75- indicates a fault after installing, check the DTC memory, erase it and check it again using the Vehicle Diagnostic Tester.