Expansion Valve, Removing And Installing: Installing

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Install in reverse order of removal and note the following:

-- Coat the new seals with refrigerant oil before installing.

-- Replace the seals -1- and -4- on the connecting tubes -2- and -3- to the evaporator.

-- Press the refrigerant pipe -2- into the expansion valve by hand.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the bolt -1- by hand and then tighten to the specified tightening specification.

NOTE:

The expansion valve is available in different versions (same housing but different control characteristic). Allocation. Refer to Parts Information.

Check the refrigerant pipes leading to the evaporator for contamination and damage.

If the heat shield insulation -2- is missing or not installed correctly, it can cause reduced output of the A/C system (change of the set control characteristic due to radiant heat).

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Vehicles with Refrigerant R134a

-- Fill the refrigerant circuit. Refer to Working with A/C Service Station .

-- Put the A/C system into operation after charging. Refer to Working with A/C Service Station .

Vehicles with Refrigerant R1234yf

-- Charge the refrigerant circuit. Refer to REFRIGERANT CIRCUIT, CHARGING .

-- Put the A/C system into operation after charging. Refer to A/C SYSTEM, OPERATING AFTER CHARGING .