Overview - Shift Unit
WARNING: This page is about a different variant/trim than selected.
- Shift Unit
- Consisting of the selector shaft and the gearshift cover
- The components cannot be separated from each other
- Back-Up Lamp Switch -F4-
- 20 Nm
- Coat the tab lightly with MoS 2 grease.
- Locking Elbow
- Relay Lever
- Installation position. Refer to Figure.
- Clip
- Secures the relay lever in the gearshift cover
- Gearshift Shaft Seal
- Replacing. Refer to SELECTOR SHAFT SEAL, REPLACING .
- Nut
- 23 Nm
- Replace after removing
- Self-locking
- Shift Lever
- Installing. Refer to Figure.
- Cap
- For the transmission ventilation
- Cap
- Spring
- Not installed on all transmissions
- Install if present