Overview - MECHATRONIC
WARNING: This page is about a different variant/trim than selected.
- Transmission
- Dual-Clutch Transmission Mechatronic -J743-
- Removing and Installing. Refer to MECHATRONIC, REMOVING AND INSTALLING .
- Bolt
- Replace after removing
- Tightening sequence. Refer to Fig 2.
- Seal
- Replace after removing
- Bolt
- 8 Nm +60°
- Replace after removing
- Clip
- Replace after removing
- Transmission Fluid Pan
- Replace after removing
- Removing and Installing. Refer to TRANSMISSION FLUID PAN, REMOVING AND INSTALLING .
Dual-Clutch Transmission Mechatronic J743 - Tightening Specification and Sequence
- Replace the bolts after removing them.
-- Tighten the bolts in three steps in the sequence shown:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1 | -1 to 9- | Install all the way by hand |
| 2 | -1 to 9- | 8 Nm |
| 3 | -1 to 9- | 45° additional turn |