Abs Control Module -J104- And Abs Hydraulic Unit -N55-, Removing And Installing, RHD With Abs Mark 70 Abs/ASR: Installing

WARNING: This page is about a different car, the 2018 Volkswagen Jetta, 2017 Volkswagen Jetta, 2016 Volkswagen Jetta, and 2015 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

CAUTION:

Do not confuse the brake lines when connecting them to the ABS Hydraulic Unit -N55-. Pay attention to the marked installation position.

NOTE:

Remove the plugs on the new ABS Hydraulic Unit -N55- only when installing the corresponding brake line.

Brake fluid may leak out if the plugs from the ABS Hydraulic Unit -N55- are removed beforehand and the unit may not be sufficiently filled or adequately bled.

WARNING:

When installing, make sure the rubber bushings are not pushed out of the bracket. Make sure the ABS Hydraulic Unit -N55- is secure after installing it otherwise malfunctions can occur.

-- Connect the battery. Refer to BATTERY .

-- Remove the Brake Pedal Actuator :V.A.G 1869/2 .

-- Bleed the brake system. Refer to HYDRAULIC SYSTEM .

If a new ABS Control Module -J104- was installed, it must be coded.

Use the Vehicle Diagnostic Tester.

Chassis
Brake System
Anti-Lock Braking System ABS/ASR Mark 70
Function
Code ABS Control Module J104