Abs Mark 70 Abs/ASR
WARNING: This page is about a different car, the 2018 Volkswagen Jetta, 2017 Volkswagen Jetta, 2016 Volkswagen Jetta, and 2015 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
- ABS Control Module -J104-
- Component location: on the ABS Hydraulic Unit -N55- inside the engine compartment on the right side.
- Do not disconnect the connector before successfully completing OBD. Switch off the ignition before disconnecting the connector
- Removing and installing. Refer to CONTROL MODULE AND HYDRAULIC UNIT .
- ABS Hydraulic Unit -N55-
- Component location: in the engine compartment on the right side
The ABS Hydraulic Unit -N55- consists of the following components:
- ABS Hydraulic Pump -V64-
- Valve block (contains intake and exhaust valves)
- The ABS Hydraulic Pump -V64- and valve block must not be separated from one another.
- Removing and installing. Refer to CONTROL MODULE AND HYDRAULIC UNIT .
- Component location: in the engine compartment on the right side
- ABS Indicator Lamp -K47-
- Component location: in the instrument cluster
- Traction Control Indicator Lamp -K86-
- Component location: in the instrument cluster
- Brake System Indicator Lamp -K118-
- Component location: in the instrument cluster
- Brake Lamp Switch -F-
- Including the Brake Pedal Switch -F47-
- Component location: on the brake master cylinder
- Removing and installing. Refer to BRAKE LAMP SWITCH, REMOVING AND INSTALLING .
- Data Link Connector
- Component location: driver side footwell cover
- Rear Wheel Bearing Unit
- The ABS sensor ring is installed in the wheel bearing
- Rear Speed Sensor --
- Removing and installing. Refer to SENSORS .
- Front Wheel Bearing Unit
- The ABS sensor ring is installed in the wheel bearing
- Front Speed Sensor --
- Removing and installing. Refer to SENSORS .