General Repair Information
Risk of destroying the fuel pump
After procedures on the fuel system it is possible to damage the fuel pump by running it dry.
-- Never let the fuel pump run dry.
-- Fill or bleed the fuel pump.
Exhaust System
There is a risk of damaging the coupling
Improper handling can cause the coupling to become damaged or to leak.
-- Coupling must not be bent more than 10°.
-- Do not load the coupling on the cable.
Ignition System
There is a risk of damaging the components.
Washing the engine as well as connecting and disconnecting wires when the engine is running can damage components.
-- Switch off the ignition before connecting and disconnecting wires.
-- Switch off the ignition before washing the engine.
Suspension, Wheels, Steering
There is a risk of damaging the components.
If the assembly mount, steering gear or subframe crossbrace is incorrectly installed, then resting the vehicle on its wheels can damage components.
-- Never place the vehicle with loosened suspension components on its wheels.
-- Never support the vehicle with loosened suspension components on the subframe or subframe crossbrace.
- Clean the work area and tools before working on the injection system.
- If the high pressure lines will not be replaced, mark them when removing. The high pressure lines may only be installed again on the same cylinder.
- Align the high pressure lines without tension. First tighten all connections hand-tight and then tighten them again to the tightening specification.
- Never bend the high pressure lines.
- It is permitted to use tools only for tightening and loosening the lines on the entire high pressure system. All other installation or removal procedures must be performed by hand without using any tools.
- All cable ties which are loosened or cut open when removing must be replaced in the same position when installing.
- Fuel hoses in the engine compartment may only be secured with spring clamps. The use of clamps or screw-type clamps is not permitted.