Selector Lever Handle, Removing And Installing: Removing

WARNING: This page is about a different car, the 2021 Volkswagen Tiguan, 2020 Volkswagen Tiguan, 2019 Volkswagen Tiguan, 2018 Volkswagen Tiguan Limited, and 2018 Volkswagen Tiguan. However, it is still accessible from the selected car via links, so may be relevant.

-- Move the selector lever into "D" position.

It is not necessary to pull out the button -arrow- manually. The button locks in the installation position by itself when the handle is removed.

Fig 1: Handle With Button In Front

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Insert the : T10383/2 between the center console and shift cover at the front and pry the shift cover out of the center console by carefully pressing the wedge downward.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the connector.

-- Cut the clamp -arrow- under the boot with a side cutter.

Fig 2: Identifying Clamp

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Pull the knob up without pressing the button.

NOTE:

Do not push the button once the handle has been removed otherwise it will not be possible to remove the handle again.