LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Volkswagen >> 2021 >> Jetta R-Line, Automatic Trans >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Assembly [CZDA,DGXA,DJXA,CWLA] >> 10 Engine Assembly >> Assembly Mounts >> Transmission Mount, Removing And Installing >> Installing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Transmission Mount, Removing And Installing: Installing

Install in reverse order of removal and note the following:

-- Replace the bolts that were tightened with an additional turn.

NOTE:

The transmission support and the transmission mount support arm must be absolutely parallel to each other before installing bolts -arrows 1-. Push the rear of the transmission upward using a floor jack if necessary.

Only remove the Engine Support Bridge: 10-222A  when bolts for the assembly mounts are tightened to tightening specification.

-- Lift the transmission using the engine support bridge spindle until the transmission support touches the support arm.

-- Check the adjustment of the subframe mount. Refer to ASSEMBLY MOUNT, CHECKING ADJUSTMENT .

-- Remove the : 10-222A  from the engine.

scientia non olet · About LEMON Manuals