Assembly Mount, Adjusting

Procedure

-- Remove the battery tray. Refer to BATTERY TRAY, REMOVING AND INSTALLING .

-- Remove the resonator for the intake air scoop. Refer to INTAKE AIR SCOOP RESONATOR, REMOVING AND INSTALLING .

-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

-- Remove the Fuel Quality Sensor -G446- on the engine mount. Refer to the appropriate Service Information .

-- Support the engine in the installation position. Refer to ENGINE, SUPPORTING IN INSTALLATION POSITION .

-- Remove and replace the bolts -arrows- for the engine mount one after the other (if this was not already done when the engine was installed).

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the bolts loosely.

Vehicles with Two Transmission Bolted Connections

Fig 1: Identifying Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolts -arrows- for the transmission mount -1- one after the other and replace them (if this was not already done when the engine was installed).

-- Install the bolts loosely.

Vehicles with Three Transmission Bolted Connections

Fig 2: Identifying Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolts -arrows- for the transmission mount one after the other and replace them (if this was not already done when the engine was installed).

-- Install the bolts loosely.

Continuation for All Vehicles:

Fig 3: Identifying Distance And Dimension

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Slide the engine/transmission assembly with an extractor lever until the following dimensions are set:

The clearance between the engine support -2- and the engine mount -1- must be -a- = 10 mm.

The casting edge on the engine support -2- must be parallel to the engine mount support arm -1-.

Dimension -b- = dimension -b-.

NOTE:

Distance -a- = 10 mm can also be checked for example using a suitable round stock.

-- Tighten the bolts on the engine mount.

Vehicles with Two Transmission Bolted Connections

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Make sure that the edges of the support arm -2- and the transmission support -1- are parallel on the transmission side.

Dimension -x- = dimension -x-.

-- Tighten the transmission mount bolts.

Vehicles with Three Transmission Bolted Connections

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Make sure that the edges of the support arm and the transmission support are parallel on the transmission side.

Dimension -x- = dimension -x-.

-- Tighten the transmission mount bolts.

Install in reverse order of removal.

Tightening Specifications

Refer to OVERVIEW - ASSEMBLY MOUNTS
Refer to OVERVIEW - CHARGE AIR SYSTEM
Overview - battery. Refer to OVERVIEW - BATTERY .
Refer to OVERVIEW - AIR FILTER HOUSING
Refer to OVERVIEW - ASSEMBLY MOUNTS