Modular Wiring Routing, Disconnecting And Connecting

Individual Wire, Removing

CAUTION:

Pyrotechnical components can deploy unintentionally.

There is a risk of injury.

- Discharge static electricity by briefly touching the door striker.

-- Remove the front seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .

-- Secure the front seat to the :VAS6136 . Refer to FRONT SEAT, MOUNT ON FIXTURE FOR SEAT REPAIR .

-- Open the cable holder -1- for the wire routing on the seat pan using a screwdriver; release the hook -2- to do this.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the corrugated tube -3- from the cable holder -1-.

-- Open the front cable holder -1- using a screwdriver to release the hook -3-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove wiring bracket from the corrugated tube -2-.

-- Disconnect the halves of the corrugated tube.

-- Cut the cable tie if necessary to remove a single wire.

NOTE:

Replacing a faulty wire or thorax airbag. Refer to WIRING HARNESS AND CONNECTOR REPAIRS .

-- Cut through the cable tie and remove the individual wire.

Individual Wire, Installing

CAUTION:

Pyrotechnical components can deploy unintentionally.

There is a risk of injury.

- Discharge static electricity by briefly touching the door striker.

Install in reverse order of removal and note the following:

-- When bundling and placing individual wires, make sure the wires are not twisted.

NOTE:

During installation, all cable ties, cable holders and clips must be installed at the same location.

Make sure the connectors are pushed in all the way and that they engage audibly.