Overview - Assembly Mounts

WARNING: This page is about a different variant/trim than selected.

Fig 1: Exploded View Of Assembly Mounts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Bolt
- Tightening sequence. Refer to Fig 2.
- Replace after removing.
Engine Support
- Tightening specification and sequence. Refer to Fig 2.
Engine Mount
- With support arm
- Removing and installing. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .
Bolt
- 40 Nm +90°
- Replace after removing.
Bolt
- 20 Nm +90°
- Replace after removing.
Bolt
- 8 Nm
Bracket
Bolt
- 60 Nm +90°
- Replace after removing.
Pendulum Support
- Removing and installing. Refer to PENDULUM SUPPORT, REMOVING AND INSTALLING .
Bolt
- Tightening specification and sequence. Refer to Fig 3.
- Replace after removing.
Bolt
- Tightening specification and sequence. Refer to Fig 3.
- Replace after removing.
Bolts
- Tightening specification and sequence. Refer to Fig 3.
- Replace after removing.
Bolt
- 60 Nm +90°
- Replace after removing.
Bolt
- 60 Nm +90°
- Replace after removing.
Bolt
- 50 Nm + 90°
- Replace after removing.
Transmission Mount
- With support arm
- Removing and installing. Refer to TRANSMISSION MOUNT, REMOVING AND INSTALLING .

Engine Support - Tightening Specification and Sequence

Fig 2: Engine Support Bolts Tightening Sequence

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Replace the bolts that were tightened with an additional turn.

-- Tighten the bolts in the steps shown in the sequence:

Step	Component	Tightening Specification/Additional Turn
1	Bolts -1 to 3-	7 Nm
2	Bolts -1 to 3-	40 Nm
3	Bolts -1 to 3-	90° additional turn

Pendulum Support - Tightening Specification and Sequence

Fig 3: Identifying Support Bracket, Pendulum And Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Replace the bolts that were tightened with an additional turn.

-- Tighten the bolts in the steps shown in the sequence:

Step	Component	Tightening Specification/Additional Turn
1	Bolts -2 and 3-	50 Nm
2	Bolts -1-	130 Nm
3	Bolts -1 to 3-	90° additional turn