Selector Shaft Seal, Replacing

Special tools and workshop equipment required 

• Press Piece - Shift Rod/Alternator: VW 423 
• Pry Lever: 80-200 
• Puller - Crankshaft/Power Steering Seal: T20143 

Procedure 

• The transmission is installed.

-- Remove the battery tray. Refer to BATTERY TRAY, REMOVING AND INSTALLING .

-- Remove the ball socket -1- on the selector lever cable from the selector shaft lever using the : 80-200  .

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolts -2- and tie up the cable bracket -3- together with the selector lever cable.

-- Remove the bolt -arrow- and the selector lever -1-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Pry out the seal using the : T20143/1  in direction of -arrow-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Coat the outer edge and sealing lips on the new seal with transmission fluid.

-- Fill the space between the sealing/dust lip -arrow- halfway with sealing grease. Refer to the Parts Information for the correct sealing grease.

-- Drive in the seal using the : VW423  all the way at the same time do not tilt the gasket.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

• The closed side of the seal -arrow- faces outward.

-- Place the selector lever -1- on the parking lock shaft and tighten the bolt -arrow-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Press the selector lever cable onto the selector lever and adjust the selector lever cable. Refer to SELECTOR LEVER CABLE, CHECKING AND ADJUSTING .

-- Install the battery tray. Refer to BATTERY TRAY, REMOVING AND INSTALLING .

Tightening Specifications 

• Refer to OVERVIEW - SHIFT MECHANISM