Transmission Fluid Pan, Removing And Installing: Removing
-- Move the selector lever to "P".
Make sure no dirt enters an >>open<< transmission.
-- Remove the noise insulation. Refer to OVERVIEW - NOISE INSULATION .
-- Remove the connecting hose between the charge air cooler and the charge air pipe. Refer to OVERVIEW - CHARGE AIR SYSTEM .
Vehicles with Secondary Air Pump
-- Press the release -arrows- and the wires -1- and remove the lines from the Secondary Air Injection Pump Motor -V101- -2-.
-- Tie the wires -1- to the side.
Continuation for All Vehicles
-- Remove the wires with the bracket from the front transmission fluid pan -arrows-.
-- Route the wires near the transmission fluid pan upward and tie them secure.
-- Drain the transmission fluid. Refer to TRANSMISSION FLUID, DRAINING AND FILLING .
Risk of destroying due to electrostatic charge.
- Do not touch the connector terminals.
- Touch a grounded object (for example the hoist) and discharge any static electricity.
-- To discharge any static electricity, touch vehicle ground with hand (without wearing a glove).
-- Release the connector twist lock for the Mechatronic by turning it in the direction of the starter in direction of -arrow- and remove it.
-- Place the : SMN372500 under the transmission.
-- Remove the clamp -3-.
-- Loosen and remove the screws -1- in a diagonal sequence.
-- Remove the oil pan -2- and if necessary loosen the oil pan by hitting lightly with a rubber hammer.