LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Volkswagen >> 2021 >> Jetta GLI Autobahn, Automatic DCT Trans >> Repair and Diagnosis >> Transmission >> Transmission Control Systems >> Controls, Housing (0GC) >> 34 Controls, Housing >> MECHATRONIC >> Transmission Fluid Pan, Removing And Installing >> Removing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Transmission Fluid Pan, Removing And Installing: Removing

-- Move the selector lever to "P".

Make sure no dirt enters an >>open<< transmission.

-- Remove the noise insulation. Refer to OVERVIEW - NOISE INSULATION .

-- Remove the connecting hose between the charge air cooler and the charge air pipe. Refer to OVERVIEW - CHARGE AIR SYSTEM .

Fig 1: Identifying Hose And Clamps
GWWN19-10337Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Vehicles with Secondary Air Pump 

GWWM26-10052Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Press the release -arrows- and the wires -1- and remove the lines from the Secondary Air Injection Pump Motor -V101- -2-.

-- Tie the wires -1- to the side.

Continuation for All Vehicles 

GWWA34-11073Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the wires with the bracket from the front transmission fluid pan -arrows-.

-- Route the wires near the transmission fluid pan upward and tie them secure.

-- Drain the transmission fluid. Refer to TRANSMISSION FLUID, DRAINING AND FILLING .

CAUTION:

Risk of destroying due to electrostatic charge.

- Do not touch the connector terminals.

- Touch a grounded object (for example the hoist) and discharge any static electricity.

-- To discharge any static electricity, touch vehicle ground with hand (without wearing a glove).

-- Release the connector twist lock for the Mechatronic by turning it in the direction of the starter in direction of -arrow- and remove it.

GWWN34-11498Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Place the : SMN372500  under the transmission.

GWWN34-11656Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the clamp -3-.

-- Loosen and remove the screws -1- in a diagonal sequence.

-- Remove the oil pan -2- and if necessary loosen the oil pan by hitting lightly with a rubber hammer.