Rear Side Window, Removing And Installing: Removing

WARNING: This page is about a different car, the 2023 Volkswagen ID.4. However, it is still accessible from the selected car via links, so may be relevant.

Removing the rear side window is described using the Flush Bonded Window Kit:VAG1474B .

The Cutting Tool for Bonded Windows:VAS6452 can also be used.

-- Remove the luggage compartment side trim panel. Refer to LUGGAGE COMPARTMENT SIDE TRIM PANEL, REMOVING AND INSTALLING .

CAUTION:

Risk of damaging component surfaces.

- Tape off the surrounding components in the visible area using commercially available adhesive tape.

-- Pull the Cutting Cord:VAS861001/1A -1- with Awl:VAG1474/2 -2- inward through the adhesive sealant.

Courtesy of \

-- Press the seal on the rear side window to the side.

-- Secure one end of the Window Removal Set - Cutting Cord:VAS861001/1A -3- on the Bonded Window Tool Kit - Pull Handle:VAG1351/1 -2- to counterhold.

Courtesy of \

-- Insert the Cutting Cord: VAS861001/1A -3- behind the seal in the window flange using the Awl: VAG1474/2 -1-.

-- Secure the end of the Cutting Cord: VAS861001/1A -1- in the vehicle interior on the Window Reel Device: VAG1654A -3-.

Courtesy of \

Tip

Increased force is necessary in the area near the clips -4-.

-- Move the Window Reel Device:VAG1654A -3- to cut free the rear side window.

-- Press the Cutting Cord: VAS861001/1A -1- against the glass using the Wedges: VAG1474/5 -2- while cutting free to ensure there is clearance on the window flange.