Rear Side Window, Removing And Installing: Installing

WARNING: This page is about a different car, the 2023 Volkswagen ID.4. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

Undamaged Window Glass

-- Refer to Undamaged Window Glass, Preparing for Installation .

New Window Glass

-- Refer to New Window Glass, Preparing for Installation .

Continuation for All Vehicles

-- Refer to Body Flange, Preparing for Installation .

-- Refer to INSTALLATION INSTRUCTIONS FOR BONDED WINDOWS .

-- Refer to Minimum Curing Times for Bonded Windows .

-- Apply the window adhesive on the rear side window all around. Refer to the appropriate Service Information .

Dimensions for bead diameter:

Height = 10 mm ± 1 mm
Width = 6.5 mm ± 0.5 mm

-- Press the rear side window -1- with the clip on in the area of the C-pillar trim.

Courtesy of \

-- Guide the rear side window -1- in the direction of -arrow A- in the guide -3- and press it on.

-- Press the rear side window -1- with clips onto the C-pillar -arrow-.

Conditions

If the rear side window -1- does not have clips, it must be aligned lengthwise at the edge of the side panel -2-.

-- Secure the rear side window -1- with commercially available adhesive tape.

-- Check the body gap dimensions using the Gauge - Gap Adjustment:3371 . For this, pay attention to the appropriate Service Information.