Power Rear Lid Opening Control Module Bracket J938, Removing And Installing: Installing
WARNING: This page is about a different car, the 2023 Volkswagen ID.4. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
-- Remove the adhesive residue and clean the adhesive surfaces. Refer to Installation Requirements for Components with Adhesive Tape .
-- Remove the protective film from the adhesive tape -2-.
-- Position the bracket -1- on the marked area -3- and press it on.
Conditions
- The minimum curing time must be complied to. Refer to Installation Requirements for Components with Adhesive Tape .