Parallel Parking Assist Sensor Bracket, Installing: Notes

WARNING: This page is about a different car, the 2023 Volkswagen Arteon. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

PDC Holder Tool Set - Drill Bit:VAS 6614/4
Assembly Tool for Park Assist Steering Sensors:VAS 895 003

Materials

Cleaning Solution:D 009 401 04

⁽¹⁾¹

⁽¹⁾	Follow the manufacturer processing instructions supplied in the packaging.

Bracket, Installing

For the following procedures, the guidelines for temperature, cleaning, removal of adhesive residue and the installation must be met. Refer to COMPONENTS WITH ADHESIVE TAPE, INSTALLATION PREPARATION .

NOTE:

After the bumper cover is painted, install the brackets.

Fig 1: Identifying Markings For Mount

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The four markings for the bracket -1- are found on the inside of the bumper cover.

-- Determine the central point -2-, if not already present.

-- The holes are pre-drilled from the inside outward using the Drill Bit:VAS 6614/4 -3- supplied in the tool kit.

Fig 2: Identifying Position Of Stamping Holes With Bolt Head

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Position the Assembly Tool for Park Assist Steering Sensors:VAS 895 003 with the bolt head -1-, washer -2- and counterholder -3- from the inside of the bumper cover -5-.

-- Position the iron punch -4- almost up to the bumper cover.

-- Push the iron punch -4- onto the bumper cover.

-- Tighten the hole stamper -1-.

NOTE:

The iron punch -4- must not rotate on the bumper cover paint.

-- By turning at the bolt head -1-, the iron punch -4- is pulled through the bumper cover material -5- -arrows-.

-- Remove the hole stamper and stamp the next holes.

Fig 3: Identifying Hole Stamper Components

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Thoroughly clean the adhesive surfaces on the bumper cover -4- and let it dry for 10 minutes.

-- Remove the protective film on double-sided adhesive tape -3- on the bracket.

-- Guide the bracket -2- on the bumper cover -4-.

-- Press on the bracket firmly near the adhesive surface -3-.

-- Repeat the steps for all brackets.

-- Any further work on the bumper cover can only be done after the minimum curing time. Refer to Minimum Curing Time .