Bevel Box, Differentiating

WARNING: This page is about a different car, the 2023 Volkswagen Arteon. However, it is still accessible from the selected car via links, so may be relevant.

The bevel boxes "0CN" or "0FN" can be installed in the vehicle.

The bevel boxes can be differentiated as follows:

Differentiation: Bevel box installed:

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The bevel box is identified by a cut-out -arrow- near the right area of the subframe.

If necessary remove the following components:

-- Noise insulation. Refer to Noise Insulation .

-- Center underbody trim panel. Refer to UNDERBODY TRIM PANELS, REMOVING AND INSTALLING .

The area indicated by the -arrow- has either the "0CN" or "0FN" designation.

Fig 1: Locating Bevel Box Identification

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Additional differentiation: bevel box removed:

Fig 2: Securing Twelve-Point Nut -A-

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The output flange on the "0CN" bevel box is secured with a nut -A-. See the Overview - Bevel Box, "0CN". Refer to OVERVIEW - BEVEL BOX COMPONENTS .

Ignore -B- and -arrows-.

The output flange on the bevel box "0FN" is secured with a circlip -A- → Overview - Bevel Box "0FN". Refer to OVERVIEW - BEVEL BOX COMPONENTS .

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

A washer -B- is located behind the circlip -A-.