Front Disc Brake Pads, Checking Thickness

NOTE:

Due to the geometry of the rims on some vehicles, an assessment or measurement or the remaining pad thickness may be hindered. Should this be the case, move the wheel to the side where the brake pad wear indicator is installed to better assess or measure the remaining pad thickness.

Procedure

-- Determine the thickness of the outer and inner pad with a visual inspection through the designed openings of the rim.

-- To better assess or measure the remaining pad thickness, if necessary move the wheel to the side where the brake pad wear indicator is installed.

-- Remove the wheel bolt caps if necessary. Refer to WHEEL BOLTS, TIGHTENING TO SPECIFICATION .

-- Mark the position of wheel in relation to the brake rotor.

-- Remove the wheel bolts and then the wheel.

-- Measure the thickness of the outer and inner brake pad.

Courtesy of AUDI OF AMERICA, LLC

a -

Pad Thickness "Without" Backing Plate

Permissible wear: 2 mm

WARNING:

With pad thickness (without backing plate) of 2 mm, the brake pads have reached their wear limit and must be replaced (repair procedure). Notify customer!

NOTE:

When replacing the disc brake pads, it is absolutely necessary to check brake rotors for wear! Checking and replacing the brake pads, if necessary, is a repair procedure.

Procedure

-- Check the brake rotor for wear. Refer to OVERVIEW - FRONT BRAKES .

-- If necessary, secure the wheel to the marked position.

-- Tighten the wheel bolts diagonally to the tightening specification. Refer to WHEEL BOLTS, TIGHTENING TO SPECIFICATION .

-- After the procedures have been completed, return the adapter to the vehicle tool kit.

-- Pull off wheel bolt caps if necessary.