Selector Lever Handle, Removing And Installing: Removing

WARNING: This page is about a different car, the 2018 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.

-- Move the selector lever into "D" position.

It is not necessary to pull out the button -arrow- manually. The button locks in the installation position by itself when the handle is removed.

Fig 1: Handle With Button In Front

Courtesy of AUDI OF AMERICA, LLC

-- Open the storage compartment door.

-- Grab and under the cover by hand and unclip by pulling upward.

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector.

-- Cut the clamp under the boot -arrow- with a side cutter.

Fig 2: Identifying Clamp

Courtesy of AUDI OF AMERICA, LLC

-- Pull the knob up without pressing the button.

NOTE:

Do not push the button once the handle has been removed otherwise it will not be possible to remove the handle again.