Catalytic Converter, Removing And Installing: Installing

WARNING: This page is about a different car, the 2020 Volkswagen Atlas, 2019 Volkswagen Atlas, and 2018 Volkswagen Atlas. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Prying Out Seal

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Insert the screwdriver -2- into the opening -arrow- on the turbocharger and pry out the seal -1-.

-- Install new seal.

-- Position the screw-type clamp in the same position on the turbocharger.

Fig 2: Installed Location of the Catalytic Converter Screw Clamp

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Position the catalytic converter on the turbocharger. Slightly secure the catalytic converter using the screw-type clamp.

-- Tighten the nuts and screw-type clamp. Refer to Figure.

-- Pay attention to the installation position of the screw-type clamp. Refer to Figure.

-- If equipped install the driveshaft. Refer to the appropriate Service Information .

Further assembly is performed in the reverse order of the removal.