Engine, Installing

WARNING: This page is about a different car, the 2020 Volkswagen Atlas, 2019 Volkswagen Atlas, and 2018 Volkswagen Atlas. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal while noting the following:

-- Make sure there is enough clearance for the subframe and radiator when installing the engine/transmission assembly.

-- Align the engine and transmission mount. Refer to ASSEMBLY MOUNTS, ADJUSTING .

-- Fasten the driveshaft. Refer to DRIVE AXLE, REMOVING AND INSTALLING .

-- Attach the front exhaust pipe and catalytic converters to the exhaust manifold. Refer to CATALYTIC CONVERTER, REMOVING AND INSTALLING .

-- Install the drive axles. Refer to DRIVE AXLE, REMOVING AND INSTALLING .

-- Install the A/C compressor. Refer to A/C COMPRESSOR .

-- Install the subframe with the steering gear. Refer to SUBFRAME WITH STEERING GEAR, REMOVING AND INSTALLING .

-- Install the noise insulation. Refer to OVERVIEW - NOISE INSULATION .

-- Fill with coolant. Refer to COOLANT, DRAINING AND FILLING .

-- Connect the Vehicle Diagnostic Tester.

-- Check all DTC memories and erase any faults, if necessary, which may have occurred during assembly.

-- Perform a road test and generate readiness code. To do so, turn on the ignition and select the following menu item. Refer to Vehicle Diagnostic Tester:

0001 - Generate readiness code