Peripheral Camera Control Module -J928-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2020 Volkswagen Arteon and 2019 Volkswagen Arteon. However, it is still accessible from the selected car via links, so may be relevant.

-- Raise the front seat into its highest position and then move it all the way back.

-- Turn off the ignition and all electrical equipment.

-- Move the ignition key outside of the vehicle to prevent switching on the ignition unintentionally.

-- Slide the module carrier -2- with the Peripheral Camera Control Module - J928- -1- outward and lift slightly at the center tunnel in direction of -arrow A-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Tilt the module carrier -2- with the Peripheral Camera Control Module -J928- -1- out of the outer mount in the direction of -arrow B-.

-- Rotate the module carrier -2- with the Peripheral Camera Control Module -J928- -1-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Unlock and disconnect the connectors from the Peripheral Camera Control Module -J928- -1-.

-- Remove the Peripheral Camera Control Module -J928- -1- from the module carrier -2- -arrow-.