Adjusting Angle
WARNING: This page is about a different car, the 2020 Volkswagen Arteon and 2019 Volkswagen Arteon. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Gauge - Frameless Window: T10391
Adjustment Dimensions
- The door window must enter 10 mm -dimension b- into the seal of the window molding.
- The window must rest against the outside of front window guide -3- -arrows-.
- The offset to the B-pillar trim -8- is 1 mm -dimension a-.
-- Loosen the nut -5-. Set the required dimensions using the adjusting screw in the nut -5-.
-- Tighten the nut -5-.
The door window must extend in the center -arrows- between inner -6- and outer window recess cover -7-.
-- Remove the front door trim panel. Refer to FRONT DOOR TRIM PANEL, REMOVING AND INSTALLING .
-- Loosen the nut -4- with the : VAG1739 or : T10471 . Set the dimensions using the adjusting screw in the nut -4-.
-- Tighten the nuts -4-.
Tightening Specifications