Calibration Unit: VAS6350A, INSTALLING AND ALIGNING: Notes
WARNING: This page is about a different car, the 2020 Volkswagen Arteon and 2019 Volkswagen Arteon. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Calibration Unit: VAS6350A
- Vehicle Diagnostic Tester
The Calibration Unit: VAS6350A consists of the following parts:
- Calibration Tool - Wheel Center Mountings: VAS6350/1
- Calibration Tool - Spacing Laser: VAS6350/2
- Calibration Tool - Linear Laser: VAS6350/3A
After performing repair work on the vehicle, it may be necessary to re-calibrate the rearview camera system. Specifically, this is the case after:
- Removing and installing the pivoting emblem with the Rearview Camera -R189-
- Collision repairs on rear lid
- An axle alignment
- A repair to the front or rear axle