Calibration System: VAS721001, INSTALLING AND ALIGNING: Notes
WARNING: This page is about a different car, the 2020 Volkswagen Arteon and 2019 Volkswagen Arteon. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Calibration System: VAS721001
- Vehicle Diagnostic Tester
After performing service work on the vehicle, it may be necessary to recalibrate the peripheral camera system. Specifically, this is the case after:
- Replacing one or more cameras
- Peripheral Camera Control Module -J928- replacement
- Software flash from the Peripheral Camera Control Module -J928-
- Record the data set on the Peripheral Camera Control Module -J928-
- Repair work on components in which a camera is installed or that influence the component location of the camera
- Wheel Alignments
- When adjusting the overlap range of the individual cameras
- The standing height of one axle changes by more than 5 mm
- The standing height of the entire vehicle changes by more than 10 mm