Lane Change Assistance Control Module - J769-/Lane Change Assistance Control Module 2 - J770-, Calibrating: Procedure:
- Turn on the -VAS6350/4- at the power switch -3-.
- The green LED -1- must turn on.
NOTE: If the red LED -2- turns on: check the -VAS6350/4-. - Connect the Vehicle Diagnostic Tester.
- Select calibration in the "Guided Fault Finding" mode. Refer to Vehicle Diagnostic Tester.
- Follow the instructions in the Vehicle Diagnostic Tester display.NOTE: The vehicle in the illustration is only a basic outline.
- Turn off the -VAS6350/4- and reposition the calibration tool.
During the program sequence, there is a prompt to switch the - VAS6350/4- from the left to the right side of the -VAS6350-.
- When installed correctly, the vehicle electrical system voltage wire must be connected at the bottom left of the calibration device (as seen in direction of travel).
- Dimension -a- = 650 mm (measured from upper edge of calibration device to floor).
- Right adjustment dimension = 675 mm (read on measurement scale -1-).
- Turn on the -VAS6350/4- at the power switch -3-.
- The green LED -1- must turn on.
- Follow the instructions in the Vehicle Diagnostic Tester display.
After successfully calibrating the lane change assistance, switch off the ignition and disconnect the diagnostic connector.