Assembly Mount, Checking Adjustment

WARNING: This page is about a different car, the 2020 Volkswagen Arteon and 2019 Volkswagen Arteon. However, it is still accessible from the selected car via links, so may be relevant.

Procedure

The following dimensions must be attained:

Fig 1: Identifying Distance And Dimension

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The clearance between the engine support -2- and the engine mount -1- must be -a- = 10 mm.
The casting edge on the engine support must be parallel to the engine mount support arm
Dimension -b- = dimension -b-.

NOTE:

Distance -a- = 10 mm can also be checked with corresponding round stock.

-- If the distance measured is too small or too large, adjust the subframe. Refer to ASSEMBLY MOUNT, ADJUSTING .