Control Module for Emergency Call Module and Communication Unit -J949-, REPLACING

WARNING: This page is about a different car, the 2020 Volkswagen Arteon and 2019 Volkswagen Arteon. However, it is still accessible from the selected car via links, so may be relevant.

Control Module for Emergency Call Module and Communication Unit -J949-, Replacing and Adapting

Current data for the "Guided Fault Finding"

-- Select the Replace control module function on the Vehicle Diagnostic Tester in the Guided Fault Finding or Guided Functions mode for the Control Module for Emergency Call Module and Communication Unit -J949-.

-- Remove the Control Module for Emergency Call Module and Communication Unit -J949-. Refer to Control Module for Emergency Call Module and Communication Unit -J949-, REMOVING AND INSTALLING .

-- Install the new Control Module for Emergency Call Module and Communication Unit -J949-. Refer to Control Module for Emergency Call Module and Communication Unit -J949-, REMOVING AND INSTALLING .

-- Select the Coding function on the Vehicle Diagnostic Tester in the Guided Fault Finding or Guided Functions mode for the Control Module for Emergency Call Module and Communication Unit -J949-.

-- Select the Adapting to Immobilizer function on the Vehicle Diagnostic Tester in the Guided Fault Finding or Guided Functions mode for the Control Module for Emergency Call Module and Communication Unit -J949-.

-- Select the Activating function on the Vehicle Diagnostic Tester in the Guided Fault Finding or Guided Functions mode for the Control Module for Emergency Call Module and Communication Unit -J949-.

-- Excluding PR number NZ3: exit Guided Fault Finding or Guided Functions .

-- Only for PR number NZ3: in Guided Fault Finding or Guided Functions , select the function "ERA Glonass, Operating" in the Vehicle Diagnostic Tester.

-- Switch off the ignition.