Peripheral Camera System, Calibrating

WARNING: This page is about a different car, the 2023 Volkswagen Atlas Cross Sport, 2022 Volkswagen Atlas Cross Sport, 2021 Volkswagen Atlas Cross Sport, and 2020 Volkswagen Atlas Cross Sport. However, it is still accessible from the selected car via links, so may be relevant.

-- The vehicle must be on a level surface.

CAUTION:

The vehicle in the illustration is only a basic outline.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Roll out the Calibration System:VAS 721 001 at the left and right near the vehicle.

The arrows -1- on the calibration patterns point in the vehicle direction of travel.

-- Install the rear and front clamping strip on the calibration patterns of the Calibration System:VAS 721 001 .

-- Align the crosshairs -2- to the front axle of the vehicle (center front wheel).

-- Align both calibration patterns parallel. The vehicle must be located in the center between both calibration patterns.

Pay attention to the following measurement requirements:

Dimension -a- 2000 to 2500 mm ± 5 mm, front and rear the same
Dimension -b- (distance from front wheel contact surface to the calibration pattern) must be even on both sides.
Dimension -c- (distance from rear wheel contact surface to the calibration pattern) must be even on both sides.

-- Set-up the requirement for the vehicle. Refer to Requirement for the calibration of the vehicle .

-- Connect the Vehicle Diagnostic Tester.

-- Perform the calibration using the Vehicle Diagnostic Tester.