Engine, Installing

WARNING: This page is about a different car, the 2023 Volkswagen Atlas Cross Sport, 2022 Volkswagen Atlas Cross Sport, 2021 Volkswagen Atlas Cross Sport, and 2020 Volkswagen Atlas Cross Sport. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal while noting the following:

-- Make sure there is enough clearance for the subframe and radiator when installing the engine/transmission assembly.

NOTE:

When installing a new engine, pay attention to the correct installation of the drive plate. Refer to DRIVE PLATE, REMOVING AND INSTALLING .

-- Align the engine and transmission mount. Refer to ASSEMBLY MOUNTS, ADJUSTING .

-- Fasten the driveshaft. Refer to DRIVESHAFT, REMOVING AND INSTALLING .

-- Attach the front exhaust pipe and catalytic converters to the exhaust manifold. Refer to CATALYTIC CONVERTER, REMOVING AND INSTALLING .

-- Install the drive axles. Refer to DRIVE AXLE, REMOVING AND INSTALLING .

-- Install the A/C compressor. Refer to A/C COMPRESSOR, REMOVING AND INSTALLING .

-- Install the subframe with the steering gear. Refer to SUBFRAME WITH STEERING GEAR, REMOVING AND INSTALLING .

-- Install the noise insulation. Refer to OVERVIEW - NOISE INSULATION .

-- Fill with coolant. Refer to COOLANT, DRAINING AND FILLING .

-- Connect the Vehicle Diagnostic Tester.

-- Check all DTC memories and erase any faults, if necessary, which may have occurred during assembly.

-- Perform a road test and generate readiness code. To do so, turn on the ignition and select the following menu item. Refer to Vehicle Diagnostic Tester:

0001 - Generate readiness code