Information Electronics Control Module 1 -J794-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2023 Volkswagen Atlas Cross Sport, 2022 Volkswagen Atlas Cross Sport, 2021 Volkswagen Atlas Cross Sport, and 2020 Volkswagen Atlas Cross Sport. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the ignition and all electrical equipment.

-- Move the ignition key outside of the vehicle to prevent the ignition from switching on unintentionally.

-- Open the glove compartment.

-- Remove any data storage device still in the Information Electronics Control Module 1 -J794-.

-- Insert two of the Radio Removal Tool: T10057 into the release slots on the Information Electronics Control Module 1 -J794- -1- until they engage.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The points at the grip eyelets of the Radio Removal Tool: T10057 must face outward.

-- Remove the Information Electronics Control Module 1 -J794- -1- from the glove compartment at the Radio Removal Tool: T10057 grip eyes.

-- Release and disconnect the connectors from the Information Electronics Control Module 1 -J794- -1-.

Equipment Levels with MOST bus

-- Insert the Fiber-Optic Repair Set - Connector Protective Caps: VAS6223/9 -1- onto the MOST bus connector -2-.

Fig 1: Fiber-Optic Cable Harness Connector And Protective Cap For Cable Connector VAS 6223/9

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

All Equipment Levels

-- Press the locking tabs on the Information Electronics Control Module 1 -J794- and remove the Radio Removal Tool: T10057 .