Overview - Fuel Delivery Unit/Fuel Level Sensor
WARNING: This page is about a different car, the 2023 Volkswagen Atlas Cross Sport, 2022 Volkswagen Atlas Cross Sport, 2021 Volkswagen Atlas Cross Sport, and 2020 Volkswagen Atlas Cross Sport. However, it is still accessible from the selected car via links, so may be relevant.
- Fuel Delivery Unit
- With the Transfer Fuel Pump -G6-
- With integrated fuel filter; the fuel filter cannot be replaced separately
- Removing and installing. Refer to FUEL DELIVERY UNIT/FUEL LEVEL SENSOR, REMOVING AND INSTALLING .
- Fill the vehicle with at least 5 liters (1.3 gallons) of fuel after installing
- Installation position. Refer to Fig 2.
- Seal
- Always replace after removing.
- Install dry
- Locking Ring
- 110 Nm
- Connector
- Pull on the connector to make sure it is engaged correctly and securely.
- Connector
- Pull on the connector to make sure it is engaged correctly and securely.
- Fuel Pump Control Module -J538-
- Check in Guided Fault Finding using the Vehicle Diagnostic Tester.
- Removing and installing. Refer to Fuel Pump Control Module -J538-, REMOVING AND INSTALLING .
- Fuel Line
- To the engine
- Do not kink
- Connector Couplings, Disconnecting and Connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
- Fuel Level Sensor -G-
- Removing and installing. Refer to Fuel Level Sensor -G-, REMOVING AND INSTALLING .
- Fuel Line
- Fuel tank component
- Do not kink
- Connector Couplings, Disconnecting and Connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
Fuel Delivery Unit Installation Position
-- Press the sealing flange downward against the spring force and move the sealing flange into the installation position.
- The tab -2- on sealing flange must lie between tabs -3 and 4- on the fuel tank.
- The arrow on the fuel tank must point to the tab -2-.
Parking/Auxiliary Heater Fuel Line
- Fuel Delivery Unit Sealing Flange
- Clamp
- Always replace after removing.
- Secure the hose connections with hose clamps that correspond to the model.
- Clamp
- Always replace after removing.
- Secure the hose connections with hose clamps that correspond to the model.
- Fuel Line
- To Metering Pump -V54-
- Removing and installing. Refer to PARKING/AUXILIARY HEATER FUEL LINE, REMOVING AND INSTALLING .
- Grommet
- Check for damages
- Fuel Line
- To the engine