Overview - Ignition System
WARNING: This page is about a different car, the 2023 Volkswagen Atlas Cross Sport, 2022 Volkswagen Atlas Cross Sport, 2021 Volkswagen Atlas Cross Sport, and 2020 Volkswagen Atlas Cross Sport. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 8 Nm +90° additional turn
- Always replace
- The tightening specification influences how the knock sensor functions
- Knock Sensor 1 -G61-
- Removing and installing. Refer to Knock Sensor 1 -G61-, REMOVING AND INSTALLING .
- Spark Plug
- 30 Nm
- Replacing the spark plugs. Refer to SPARK PLUGS, REPLACING .
- Remove and install using Spark Plug Removal Tool :3122B
- Spark Plug Connectors
- Assembling. Refer to Ignition Coil with Power Output Stage and Spark Plug Connector, Assembling .
- Ignition Coil with Power Output Stage
- Ignition Coil 1 with Power Output Stage -N70-
- Ignition Coil 2 with Power Output Stage -N127-
- Ignition Coil 3 with Power Output Stage -N291-
- Ignition Coil 4 with Power Output Stage -N292-
- Removing and installing. Refer to IGNITION COILS WITH POWER OUTPUT STAGES, REMOVING AND INSTALLING .
- Bolt
- 10 Nm
- Nut
- 10 Nm
- For the ground wire
- Dependent on the version
- Bolt
- 9 Nm
- Camshaft Position Sensor 3 -G300-
- Check the O-ring for damage before installing
- Removing and installing. Refer to Camshaft Position Sensor 3 -G300-, REMOVING AND INSTALLING .
- O-Ring
- Replace if damaged
- O-Ring
- Replace if damaged
- Camshaft Position Sensor -G40-
- Check the O-ring for damage before installing
- Removing and installing. Refer to Camshaft Position Sensor -G40-, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- O-Ring
- Replace if damaged
- Engine Speed Sensor -G28-
- Check the O-ring for damage before installing
- Removing and installing. Refer to Engine Speed Sensor -G28-, REMOVING AND INSTALLING .
- Bolt
- 4 Nm + 45° additional turn