Peripheral Camera System, Calibrating
- The vehicle must be on a level surface.NOTE: The vehicle in the illustration is only a basic outline.
- Roll out the -VAS721001- at the left and right near the vehicle.
- The arrows -1- on the calibration patterns point in the vehicle direction of travel.
- Install the rear and front clamping strip on the calibration patterns of the -VAS721001-.
- Align the crosshairs -2- to the front axle of the vehicle (center front wheel).
- Align both calibration patterns parallel. The vehicle must be located in the center between both calibration patterns.
Pay attention to the following measurement requirements:
- Dimension -a- 2000 to 2500 mm ± 5 mm, front and rear the same
- Dimension -b- (distance from front wheel contact surface to the calibration pattern) must be even on both sides.
- Dimension -c- (distance from rear wheel contact surface to the calibration pattern) must be even on both sides.
- Set-up the requirement for the vehicle. Refer to Peripheral Camera, Calibrating
- Connect the Vehicle Diagnostic Tester.
- Perform the calibration. Refer to Vehicle Diagnostic Tester.