Air Conditioning (A/C) Compressor: Removal

WARNING: This page is about a different car, the 2017 Ford Expedition and 2016 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If installing a new Air Conditioning(A/C) compressor due to an internal failure of the old unit, the following procedures must be carried out to remove contamination from the A/C system. Failure to remove contamination from the A/C system, if present, will result in poor A/C performance and/or damage to the new A/C compressor and other components.

Carry out the A/C flushing procedure after a new A/C compressor has been installed. Refer to the A/C System Flushing general procedure in Climate Control System General Information and Diagnostics

NOTE: Removal steps in this procedure may contain installation details.

NOTE: Installation of a new receiver/drier cartridge is not required when repairing the A/C system except when there is physical evidence of contamination from a failed A/C compressor or damage to the receiver/drier cartridge.

1.

With the vehicle in NEUTRAL, position it on a hoist. Refer to Jacking and Lifting .

2.

Recover the refrigerant. Refer to Climate Control System General Information and Diagnostics .

3.

Remove the drive belt from the A/C compressor pulley. Refer to Accessory Drive .

4.

NOTE: Make sure that all openings are sealed.

Position aside turbocharger inlet tube. Loosen the clamp at the turbocharger inlet tube to air cleaner outlet pipe.
- Tighten to 5 Nm (44 lb-in).