Removal And Installation

WARNING: This page is about a different car, the 2016 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If a new DSM has been installed, all seat soft stops must be reset. If a new seat track or new seat backrest has been installed, only reset the soft stops for that component being installed new. To reset the soft stops, refer to Principles of Operation in this article.

1.

Remove the seat backrest. Refer to Seat Backrest - Front .

2.

Remove the seat cushion cover. Refer to Seat Cushion Cover - Front .

3.

NOTE: Transfer components to the new seat track as necessary.

To install, reverse the removal procedure.

4.

NOTE: This step is only necessary when installing a new driver memory seat track.

Operate the seat in all directions through the full range of travel to set soft stops and avoid a premature stopping point occurrence after the vehicle is returned to the customer.