Control Module, Attaching To Hydraulic Unit: Notes

WARNING: This page is about a different car, the 2016 Volkswagen e-Golf and 2015 Volkswagen e-Golf. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

ESD Work Surface:VAS6613
Torque Screwdriver:VAG1624
TORX^® insert T25

NOTE:

Excessive shaking (for example, dropping, impact) may destroy the control module. The control module must then no longer be used.

Surface must be cleaned before assembling.

-- Place the control module on the hydraulic unit without tilting.

-- Install the hydraulic unit and control module with the new included TORX^® bolts switching back and forth in two steps according to the tightening specification.

NOTE:

The hydraulic unit threads cannot be re-cut to secure the control module. In the threads are damaged (bolts are difficult to install by hand or the bolts cannot be tightened to the tightening specification), the hydraulic unit must be replaced.