Sensor Electronics Control Module, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

CAUTION:

Risk of destroying the Sensor Electronics Control Module -J849-.

Protect the Sensor Electronics Control Module -J849- from bumps or impact: A Sensor Electronics Control Module -J849- that has fallen to the ground can no longer be used.

-- Mount the Sensor Electronics Control Module -J849- on the four bolts.

NOTE:

Make sure it is in the correct installation position. The connector faces the direction of travel.

-- Ensure a stress-free seating on the mounting.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

To install the Sensor Electronics Control Module -J849- -2- free of tension, install all the nuts -1- loosely and then tighten them diagonally.

-- Install the center console cover. Refer to CENTER CONSOLE .

-- If the Sensor Electronics Control Module -J849- is being replaced, select the "Replace" function for the Sensor Electronics Control Module -J849- on the Vehicle Diagnostic Tester in Guided Functions .