10.3 Front Sensor, Removing and Installing
Removing
- Turn off the ignition and all electrical equipment.
- Remove the ignition key, if equipped.
- Loosen the front section of the wheel housing liner; do not completely remove it. Refer to Front Wheel Housing Liner, Removing and Installing.
- Press both locking tabs in the direction of -arrow A- and, at the same time, push the sensor -1- inward from the outside.
- Release and disconnect the connector -2-.
Installing
Install in reverse order of removal and note the following:
- Check the decoupling ring (black silicone ring) on the sensor head for damage and replace if necessary.
- When inserting the sensor into the sensor mount, make sure that the decoupling ring (black silicone ring) is seated correctly on the sensor head.
- Both sensor mount retaining brackets must engage audibly when Installing the sensor.