Overview - Selector Mechanism
- Handle with Shift Cover
- Do not remove the handle unnecessarily. Only the cover must be unclipped for the emergency release. Refer to EMERGENCY RELEASE FROM P .
- Removing and installing. Refer to SELECTOR LEVER HANDLE, REMOVING AND INSTALLING .
- Bolts
- 8 Nm
- Quantity: 4
- Selector Mechanism
- With integrated Selector Lever Sensor System Control Module -J587- with Selector Lever -E313-, Tiptronic Switch -F189-, Selector Lever Park Position Lock Switch -F319- and Shift Lock Solenoid -N110-.
- Removing and installing. Refer to SELECTOR MECHANISM, REMOVING AND INSTALLING .
- Lock Washer
- Replace after removing
- Nut
- 8 Nm
- For selector mechanism to body
- Quantity: 4
- Selector Lever Cable
- Do not grease the selector lever cable.
- Removing and installing. Refer to SELECTOR LEVER CABLE, REMOVING AND INSTALLING .
- Checking and Adjusting. Refer to SELECTOR LEVER CABLE, CHECKING AND ADJUSTING .
- Bolt
- 13 Nm
- Selector lever cable adjusting bolt
- Cover
- Replace after removing.
- Bolt
- 20 Nm
- Quantity: 2
- Clip
- Replace after removing
- Installation position: the offset side of the clamp points to the selector lever
- Cable Bracket
- For the selector lever cable
- Grommet
- Clipped in the cable bracket
- For the cable mounting bracket to transmission
- Spacer
- Installation position: the larger diameter points to the transmission
- Nut
- Bolt
- 10 Nm +90°
- Replace after removing
- Selector Lever