Overview - Transmission

Fig 1: Exploded View Of Transmission

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Transmission Fluid Pan
- Removing and installing. Refer to TRANSMISSION FLUID PAN, REMOVING AND INSTALLING .
Gasket
- Replace after removing
Bolt
- Replace after removing
- Tightening specification and sequence. Refer to Figure.
- For attaching the DSG Transmission Mechatronic -J743- to the transmission housing
- Quantity: 10
DSG Transmission Mechatronic -J743-
- Allocate using the transmission code letters. Refer to the Parts Information.
- Removing and installing. Refer to MECHATRONIC, REMOVING AND INSTALLING .
Bolt
- Tightening specification and sequence. Refer to Figure.
- Replace after removing
- Quantity: 5
Clutch End Cover
- For the dual clutch
- Removing and installing. Refer to CLUTCH END COVER, REMOVING AND INSTALLING .
Dual Clutch
- Removing. Refer to DUAL CLUTCH, REMOVING .
- Installing. Refer to DUAL CLUTCH, INSTALLING .
Bleed Pipe
- Replace after removing
- Pressed into the transmission housing
Bleed Cap
- Placed on bleed pipe
Nut
- 20 Nm
Selector Lever
- Insert so that master spline aligns with shift rod
Seal
- Replacing. Refer to SELECTOR SHAFT SEAL, REPLACING .
Bolt
- 20 Nm +90°
- Replace after removing
Transmission Fluid Cooler
- Removing and installing. Refer to TRANSMISSION FLUID COOLER, REMOVING AND INSTALLING .
O-rings
- Replace after removing
Cable Bracket
- For the selector lever cable
Bolt
- 20 Nm +90°
- Replace after removing
- Quantity: 2
Filter Housing
- 20 Nm
O-ring
- Replace after removing
Transmission Fluid Filter
- Information on changing filter. Refer to TRANSMISSION FLUID FILTER, REMOVING AND INSTALLING .
- Replacing. Refer to TRANSMISSION FLUID .
Ignore, Discontinued
Ignore, Discontinued
Alignment Pin
- For centering the transmission fluid pump to the transmission housing
- Quantity: 2
Seal
- Replace after removing
Transmission Fluid Pump
- Removing and installing. Refer to TRANSMISSION FLUID PUMP, REMOVING AND INSTALLING .
Transmission Fluid Pump Cover
- Replace after removing
- Removing and installing. Refer to TRANSMISSION FLUID PUMP, REMOVING AND INSTALLING .
- With seal
Bolt
- Replace after removing
- Tightening specification and sequence. Refer to Figure.
- Quantity: 4
Bolt
- Replace after removing
- Quantity: 4
Overflow Pipe
- 3 Nm
- Plastic
- To drain the transmission fluid, remove the drain and check plug -item ) OVERVIEW - TRANSMISSION - List Item: Fluid Drain and Check Plug and remove the overflow pipe.
- The length of the overflow pipe determines the fluid level inside the transmission
- Allocate according to the Parts Information.
Seal
- Replace after removing
Fluid Drain and Check Plug
- 45 Nm
- There is an overflow pipe with a 8 mm inner hex behind this bolt -item ) OVERVIEW - TRANSMISSION - List Item: Overflow Pipe
- Drain the transmission fluid via the drain- and check plug and removed overflow pipe.