13.3.2 Blind Spot Detection Control Modules - J1086-/-J1087-, Removing and Installing, Wagon
Removing
- Turn off the ignition and all electrical equipment.
- Remove the ignition key, if equipped.
- Remove the rear bumper. Refer to Body Exterior; Rear Bumper; Bumper Cover, Removing and Installing.
- Release and disconnect the connector -3-.
- Release the retaining tab -4- on the bracket -5-.
- Remove the Blind Spot Detection Control Module - J1086-/Blind Spot Detection Control Module 2 - J1087- -1- from the bracket -5- in direction of -arrow-.
- Remove the nuts -6-.
- Remove the bolt -2-.
- Remove the bracket -5- from the body.
Installing
Install in reverse order of removal and note the following:
The blind spot detection calibration normally occurs automatically.
Static calibration is only required when there is a DTC memory entry.
Tightening Specifications
- Refer to 13.1 Overview - Blind Spot Detection